MYLEX CORPORATION

DAC960E

Data bus:                32-bit EISA
Size:                    Three-quarter length, full-height card
Hard drive supported:    Up to twenty-one Fast SCSI-2 devices
Floppy drives supported: None

[Image]

                           CONNECTIONS

                   Function                         Location

  50-pin SCSI channel 2 connector - internal           J2

  50-pin SCSI channel 1 connector - internal           J3

  50-pin SCSI channel 0 connector - internal           J4

  50-pin SCSI channel 0 connector - external           J6

  2-pin connector - SCSI active LED              JP1/pins 1 & 2

  2-pin connector - EISA active LED              JP1/pins 3 & 4

  2-pin connector - write pending LED            JP1/pins 5 & 6

                        USER CONFIGURABLE SETTINGS

               Function                    Location           Setting

  »    Factory configured - do not            JP2               N/A
       alter

  »    Termination power enabled for          JP3             Closed
       SCSI channel 2

       Termination power disabled for         JP3              Open
       SCSI channel 2

  »    Termination power enabled for          JP4             Closed
       SCSI channel 1

       Termination power disabled for         JP4              Open
       SCSI channel 1

  »    Termination power enabled for          JP5             Closed
       SCSI channel 0

       Termination power disabled for         JP5              Open
       SCSI channel 0

  Note: Enable termination power when the controller is installed at one
  end of a channel and disable termination power when a channel is not at
  the end of SCSI cable. When both connectors J4 and J6 use channel 0,
  disable termination to that channel.

   DRAM CONFIGURATION

  Size       Bank 0

   2MB    (1) 512 x 36

   4MB     (1) 1M x 36

   8MB     (1) 2M x 36

  16MB     (1) 4M x 36

  32MB     (1) 8M x 36